Illustrations – FUJITSU DISK DRIVES MHM215OAT User Manual
Page 19

Contents
xiv
C141-E104-02EN
Illustrations
Figures
Figure 1.1
Current fluctuation (Typ.) at +5V when power is turned on 1-7
Figure 2.1
Disk drive outerview (the MHL Series and MHM Series) 2-2
Figure 2.2
Configuration of disk media heads 2-3
Figure 2.3
1 drive system configuration 2-4
Figure 2.4
2 drives configuration 2-4
Figure 3.1
Dimensions (MHL/MHM series) 3-2
Figure 3.2
Orientation (Sample: MHL2300AT) 3-4
Figure 3.3
Mounting frame structure 3-5
Figure 3.4
Location of breather 3-6
Figure 3.5
Surface temperature measurement points
(Sample: MHL2300AT) 3-7
Figure 3.6
Service area (Sample: MHL2300AT) 3-8
Figure 3.7
Handling cautions 3-9
Figure 3.8
Connector locations (Sample: MHL2300AT) 3-10
Figure 3.9
Cable connections 3-11
Figure 3.10 Power supply connector pins (CN1) 3-12
Figure 3.11 Jumper location 3-12
Figure 3.12 Factory default setting 3-13
Figure 3.13 Jumper setting of master or slave device 3-13
Figure 3.14 CSEL setting 3-14
Figure 3.15 Example (1) of Cable Select 3-14
Figure 3.16 Example (2) of Cable Select 3-15
Figure 4.1
Head structure 4-3
Figure 4.2
Power Supply Configuration 4-5
Figure 4.3
Circuit Configuration 4-6
Figure 4.4
Power-on operation sequence 4-8
Figure 4.5
Read/write circuit block diagram 4-12
Figure 4.6
Frequency characteristic of programmable filter 4-13
Figure 4.7
Block diagram of servo control circuit 4-15
Figure 4.8
Physical sector servo configuration on disk surface 4-19
Figure 4.9
Servo frame format 4-20
Figure 5.1
Interface signals 5-2
Figure 5.2
Execution example of READ MULTIPLE command 5-20