Friedrich 920-087-09 (12/10) - Manual (Page 18)

18
1. Lift.unit.level.and.slide.unit.into.wall.sleeve.until.from.seal.rests.
firmly.against.front.of.wall.sleeve.
2. Locate.the.four.supplied.chassis.mounting.screws..Insert.the.
screws.through.the.chassis.mounting.flange.holes.that.are.aligned.
with.the.speed.nuts.in.the.wall.sleeve..Tighten.all.four.screws.(two.
per.side)..
3. Place.tabs.over.top.rail.(1)...Push.inward.at.bottom.until.panel.
snaps.into.place.(2).
4. Reinstall.front.panel..See.Figure.24..
Figure 23
Securing Unit
FRP023
POWER
SUPPLY
CORD
High Med Low Fan Cool
Heat
Fan Spee d Mode Temperature
Power
Figure 24
Replacing Front Panel
CAUTION
Excessive Weight Hazard
Use two or more people when installing
your air conditioner.
Failure to do so can result in back
or other injury.
NOTICE
Copper refrigerant tubes are NOT handles.
Do NOT use tubing to lift or move chassis.
Chassis Installation
To.remove.the.front.cover,.pull.the.bottom.end.forward.and.lift.it.up.to.clear.
the.L.bracket.across.the.top.of.the.chassis.
5. Plug.the.cord.(if.applicable).into.the.appropriate.receptacle...
Restore.power.to.the.unit.
FRP024
1
2