Friedrich 920-087-09 (12/10) - Manual (Page 17)

17
FRP020
SHIPPING
TAPE
Figure 20
Shipping Tape Location
FRP021
REMOVE SHIPPING
SCREW IF PRESENT
Figure 21
Shipping Screw Location
Figure 22
Removing Front Panel
CAUTION
Unit Damage Hazard
Failure to follow this caution may result in equipment damage
or improper operation.
Failure to remove shipping tape and screw will prevent fresh
air vent door from opening and may result in damage to vent
door cable.
3.. Carefully.remove.shipping.tape.from.the.front.panel.and.vent.door...
See.Figure.20
4. Remove.shipping.screw.from.the.vent.door,.if.present..See.Fig.21..
5.. Remove.front.panel..See.Figure.22.
Pull.out.at.the.bottom.to.release.it.from.the.tabs.(1)...Then.lift.up.(2).
NOTE:. If.the.unit.is.mounted.flush.to.the.floor,.the.service.cord.MUST.
be.rerouted.at.the.bottom.of.the.front.cover.on.the.side.closest.
to.the.receptacle...A.notch.MUST.be.made.in.the.front.cover.
side.where.the.cord.exits.the.unit...It.is.the.responsibility.of.
the.installer.to.create.an.exit.notch..
FRP022
2
1