FUJITSU M3000 - Manual (Page 49)

4-1
C H A P T E R
4
Connecting the Domain to the
Network
This chapter explains how to establish a network for the SPARC Enterprise M3000
server. It contains the following sections:
■ Section 4.1, “Network Configuration Overview” on page 4-1
■ Section 4.2, “Connecting to the Network” on page 4-2
■ Section 4.3, “Verifying the Network Connection” on page 4-3
■ Section 4.4, “Starting the Solaris Operating System” on page 4-3
■ Section 4.5, “Verifying Operation by Running SunVTS” on page 4-4
4.1 Network Configuration Overview
This section provides an overview of the network connections of the SPARC
Enterprise M3000 server.
You can connect the SPARC Enterprise M3000 server to the network through one of
the four onboard Gigabit Ethernet (GbE) ports.
Alternatively, you can mount a LAN card prepared by the customer in a PCI slot to
connect the server to the network.
FIGURE 4-1 shows a user network, which is for
user access to the domain.
Note – To isolate the domain from the network, skip the steps in Section 4.2,
“Connecting to the Network” on page 4-2 and Section 4.3, “Verifying the Network
Connection” on page 4-3 .