Frymaster H50 Series - Manual (Page 91)

2-28
2.11.4 FootPrint III Square Drain Components, Rear Flush Configuration
NOTE: The assemblies shown represent typical FP III rear flush
drain configurations. All components are illustrated, but there are
many other possible combinations of these components.
3
1
2
10
10a
9
4
5
6
7
13
15
19
11
11a
18
17
14
17
12
9
3
16
FPH250
FPH250-2R
FPH450-2L
FPH450-4R
ITEM PART # COMPONENT
1 806-6374SP Clamp Assembly
2 816-0420 Boot (Connection Seal)
3 KIT-0257SP Clamp Assembly and Seal Kit
4 826-1382 Wing Nut (Pkg. of 10)
5 811-0932 Vent Tube, Teflon, ⅜” OD (FP III units manufactured after Sep 97) per foot
6 810-1372 Fitting, 90°, Vent Tube (for use with Item 5)
7 816-0135 O-Ring (Valve)
8 823-2199 Left End Section, Dual Vat, 4.06” Long
9 823-2197 Left End Section, Full Vat, 7.95” Long
10 823-2211 Drain Outlet Section, Closed, Full Vat, 18.60” Long (one bracket)
10a 823-2210 Drain Outlet Section, Closed, Dual Vat, 15.86” Long (two brackets)
11 823-2204 Drain Outlet Section, Open, Dual Vat, 11.55” Long (one bracket
11a 823-2192 Drain Outlet Section, Open, Dual Vat, 11.55” Long (two brackets)
12 823-2200 Drain Outlet Section, Open, Full Vat, 23.38” Long (two brackets)
13 823-2207 Drain Outlet Section, Open, Full Vat, 23.38” Long (three brackets)
14 823-2202 Drain Section, Dual Vat, 11.55” Long (two brackets)
15 823-2233 Drain Section, Full Vat, 15.39” Long (one bracket)
16 823-2193 Drain Section, Left End, Dual Vat, 3.57” Long (stud left of center)
17 823-2212 Drain Section, Right End, Dual Vat, 3.57” Long (stud right of center)
18 823-2194 Right End Section, Dual Vat, 4.06” Long
19 823-2198 Right End Section, Full Vat, 7.89” Long