Fluke 5020A User Manual
Page 94
5020A
Users Manual
6-24
Specifying the MIN, MAX, or DEF parameter returns the minimum, maximum, or
default value respectively.
CALCulate[
Sets the display resolution.
Example: CALC:PAR2:RES 2
The PARameter suffix,
humidity resolution (2). The
use. Specifying the MIN, MAX, or DEF parameter sets the display resolution to the
minimum, maximum, or default value respectively. This command may be password
protected (see Password Commands).
FETCh? [
Returns a comma-delimited list of the most recent measurements for the specified
channel or for both channels.
Example 1: FETC? 1
Response: 25.576,29.30
or
Response: 1,1,25.629,C,29.32,%,2003,9,16,11,2,38
Example 2: FETC?
Response: 25.582,29.32,26.341,37.96
or
Response: 1,1,25.629,C,29.29,%,2,0,C,0,%,2003,9,16,11,1,42
The
parameter is omitted, the most recent measurements on both channels are returned. If a
channel is disabled or no sensor is connected, the measurement values returned for that
channel are 0. This command does not affect the measurement action.
If the extended format setting is OFF (see FORMat:TDST:STAT), the measurement
values are returned in a comma-delimited format as follows:
The temperature values are always in the current temperature units. The humidity values
are always in %RH.
If the extended format setting is ON, the measurements are returned in a comma-
delimited format as follows: p>, previously or 1 if these are new measurement values. If no channel number was specified, the measurements on both channels are returned (X = 1; Y = 2). Otherwise, only the measurements on the specified channel are returned. If only new readings are desired, the FORM:TDST:STAT command can be used to enable the extended format option and any readings in which the value of the first field is 0 can be ignored.
The measure status (