Fortinet FortiGate 5140-R User Manual
Page 9
FortiGate-5140 chassis
FortiGate-5140 shelf managers
FortiGate-5140-R Chassis Guide
01-30000-87705-20090108
9
The FortiGate-5140 shelf managers control chassis power up and power down, chassis
power distribution, monitor chassis operating parameters, monitor and control chassis
cooling, and can signal alarms if the chassis encounters problems. All FortiGate-5000
modules installed in the chassis communicate with the shelf managers.
The FortiGate-5140 shelf managers are factory installed. In most cases users do not have
to install or configure the shelf managers.
Each shelf manager has two ethernet interfaces (ETH 0 and ETH 1). You can connect to
ETH 0 from the shelf manager front panel. ETH 1 connects to the FortiGate-5140
backplane.
The shelf managers detect alarm conditions and communicate alarm signals to the
FortiGate-5140 shelf alarm panel. The shelf alarm panel also contains serial interfaces for
connecting to the shelf managers.
The shelf managers are hot swappable. You can remove a shelf manager by opening the
extraction lever until the hot swap LED starts blinking. When the hot swap LED turns solid
blue you can remove the shelf manager from the FortiGate-5140 chassis.
Figure 3: FortiGate-5140 shelf manager front panel
Table 2: FortiGate-5140 shelf manager LEDs
LED
State
Description
ETH 0
ETH 1
10/100
Yellow
The Ethernet interface is connected at 100 Mbps.
link/Act Green
Blinking LED indicates network traffic.
Off
No link.
STATUS
Green
This shelf manager is operating normally as the active shelf
manager. Usually the primary shelf manager operates as the
active shelf manager.
Red
This shelf manager is operating normally as the backup shelf
manager. Usually the secondary shelf manager operates as the
standby shelf manager.
HOT SWAP
Off
The shelf manager is not ready to be removed.
Blue
The shelf manager is ready to be removed.
Long blink
The shelf manager is starting up after being inserted into the
chassis.
Short blink
The shelf manager is shutting down in preparation for being
removed from the chassis.
10/100
link/Act
ETH0
Service
RESET
ST
A
TUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
Retention
Screw
ETH 0 and 1 network
activity LEDs
ETH0
100base-T
Ethernet
Status
LEDs
Handle
Reset
Button
Hot Swap
LED