FUJITSU Disk Storage System DX60 - Manual (Page 107)

Appendix A Event Notification Message List
A.2 Message List
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
107
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
A.2.4 Informational Messages
This section describes the messages that are sent when the severity is Information.
■ Informational message list
●
When the event type is "I"
The following messages are sent when an information-level event occurs:
Event type
and event
code
SNMP
Trap
Upper: Message
Remarks
Middle: Detail information
Trap
No.
Lower: Description
I 00000001 9 Power on completed ($a) These messages
are notified when
"Power on
Completed" is
enabled for
Informational Level
in the event
notification setting.
Detail information is not displayed.
The device is powered ON.
$a: VxxLxx-xxxx (Firmware version)
I 00000002 9 Controller firmware updated ($a) These messages
are notified when
"Controller
Firmware update" is
enabled for
Informational Level
in the event
notification setting.
Detail information is not displayed.
Controller firmware version is updated.
$a: VxxLxx-xxxx (Firmware version)
I 00000011 9 Snap Data Pool (SDP) capacity reached $a%. (Policy Level1:
Threshold $b%) These messages
are notified when
"Informational
message defined by
SDP policy" is
enabled for
Informational Level
in the event
notification setting.
Detail information is not displayed.
Snap Data Pool (unencrypted) usage rate exceeds the threshold
(Level1) $a% and reaches $b%.
$a: Usage rate of Snap Data Pool
$b: Threshold of Snap Data Pool
I 00000011 9 Snap Data Pool (SDP) capacity of the encryption reached $a%. (Policy
Level1: Threshold $b%)
Detail information is not displayed.
Snap Data Pool (encrypted) usage rate exceeds the threshold (Level1)
$a% and reaches $b%.
$a: Usage rate of Snap Data Pool
$b: Threshold of Snap Data Pool