FUJITSU Disk Storage System DX60 - Manual (Page 101)

Appendix A Event Notification Message List
A.2 Message List
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
101
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
M E207000B 7 E207000B NOT READY(11:Power Off/Fail Incomplete) These messages
are notified when
the relevant event
occurs.
The device is in Not Ready status.
Failed to power off. Or the device power turns off
immediately after the device powers on.
M E207000C 7 E207000C NOT READY(12:Backup Fail)
The device is in Not Ready status.
Backup failed.
M E207000D 7 E207000D NOT READY(13:Multi CM Down)
The device is in Not Ready status.
Adjoining CMs with LUs are degraded.
M E207000E 7 E207000E NOT READY(14:Machine Down Recovery End)
The device is in Not Ready status.
Machine down recovery is performed.
M E207000F 7 E207000F NOT READY(15:Machine Down Recovery Failed)
The device is in Not Ready status.
Failed to perform machine down recovery.
M E2070010 7 E2070010 NOT READY(16:DE Build Error)
The device is in Not Ready status.
Failed to configure DE because of miniSAS cable errors
or FC cable errors.
M E2070011 7 E2070011 NOT READY(17:CM Memory Shortage)
The device is in Not Ready status.
Memory capacities are smaller than the minimum value in
multiple CMs.
M E2070015 7 E2070015 NOT READY(21:Configuration Data restored from
System Disk)
Maintenance is performed for the CM in cold mode.
The ETERNUS DX Disk storage system normally powers
off and then on, and the status becomes Ready.
M E2070016 7 E2070016 NOT READY(22:No Version)
The device is in Not Ready status.
The version table is invalid.
Event type
and event
code
SNMP Trap Upper: Message
Remarks
Trap
No.
Trap
Maintenance
Info
Lower: Description