Fortinet FortiGate 5001FA2-LENC - Manual (Page 24)

FortiGate-5001FA2-LENC Security System Guide
24 01-30000-76602-20080606
Factory default settings Quick Configuration Guide
Command Line Interface (CLI)
The CLI is a full-featured management tool. Use it to configure the administrator
password, the interface addresses, the default gateway, and the DNS server
addresses.
Requirements:
• The serial connector that came packaged with your FortiGate-5001FA2-LENC
board.
• Terminal emulation application (for example, HyperTerminal for Windows) on
the management computer.
Factory default settings
The FortiGate-5001FA2-LENC unit ships with a factory default configuration. The
default configuration allows you to connect to and use the
FortiGate-5001FA2-LENC web-based manager to configure the
FortiGate-5001FA2-LENC board onto the network. To configure the
FortiGate-5001FA2-LENC board onto the network you add an administrator
password, change the network interface IP addresses, add DNS server IP
addresses, and, if required, configure basic routing.
Table 5: FortiGate-5001FA2-LENC factory default settings
Operation Mode NAT/Route
Administrator Account User Name: admin
Password: (none)
port1 IP/Netmask 192.168.1.99/24
port2 IP/Netmask 192.168.100.99/24
Default route Gateway: 192.168.100.1
Device: port2
Primary DNS Server: 65.39.139.53
Secondary DNS Server: 65.39.139.53
Note: At any time during the configuration process, if you run into problems, you can reset
the FortiGate-5001FA2-LENC board to the factory defaults and start over. From the
web-based manager go to System > Status find System Operation at the bottom of the
page and select Reset to Factory Default. From the CLI enter execute factory reset.