FUJITSU IMAGE SCANNER FI-486PRRE - Manual (Page 206)

183
7.3 Setup Mode Details
7
SETUP MODE
3) At , press (Left arrow button) or (Right arrow button) and select
consumable error process.
By pressing (Enter button), appears on the LCD.
4) At , specify the number of scans to get Consumables replacement
message.
Each time (Left arrow button) is pressed, the counter value decrements by 10,000.
Each time (Right arrow button) is pressed, the counter value increments by 10,000.
5) Press (Enter button) and the setting becomes valid.
Press (EXIT button) at or , the LCD display changes to
.
Press (EXIT button) at and the LCD display goes back to [Ready]
screen.
(1) [Stop] is blinking: When the consumables replacement condition is
reached, the Consumables replacement message
(Abrasion alarm) is shown on the LCD and scanning
stops.
(2) [Message] is blinking: When the consumables replacement condition is
reached, the Consumables replacement message
(Abrasion alarm) is shown on the LCD but the scan-
ning continues.
0 8 N C
s
!
0
T
0
m
=
A r l a
0 e t h 0 0 e 3
- 2