Fostex D1624 - Manual (Page 58)

D824/D1624 Reference Manual (Locate Function)
58
AUTO PUNCH IN point
LOCATE
PLAYBACK
LOCATE
PLAYBACK LOCATE
START
LOCATE
START
AUTO RTN END point AUTO RTN START point
STOP
PLAYBACK
LOCATE
PLAYBACK
START
Auto Play function
The Auto Play function allows the recorder to start play back automatically from the located point.
AUTO PLAY mode should be turned on before you execute the Direct Locate function described
above.
This function is effective within 24 ABS hours. Therefore, if playback continues over the recording end point, the
recorder will still continue counting the time. Also, when the recorder locates ABS REC END, it will continue
counting the time from the recording end point. (However, the unit does not access the disk after reaching the
recording end point.)
1. Press the AUTO RTN/AUTO PLAY key to turn on
the [AUTO PLAY] LED.
2. Press the LOCATE key, or memory key.
The recorder locates the point and plays as shown
in the diagram.
3. Press the STOP button to stop the unit.
• You can set a preroll time in the [Preroll Time ?] menu
in SETUP mode so that the recorder will start playback
preroll time before the locate point. You can set the
preroll time from 0 to 10 seconds. Refer to the chapter
“Changing the Initial Settings (SETUP Mode)” on page
“
108 .”
Auto Return function
This function allows the recorder to play data up to the AUTO RTN END point, then automatically
locate the AUTO RTN START point as shown in the diagram below. To enable this function, AUTO
RTN mode should be on and the AUTO RTN START point and AUTO RTN END point should already
be set.
Automatic locating to the AUTO RTN START point
subsequent to playback to the AUTO RTN END point.
1. Store the AUTO RTN START and AUTO RTN END
points.
Refer to the chapter “Storing a Locate Point (Edit Point)”
on page “
54 ” for information on storing the desired
points in the AUTO RTN START key and the AUTO RTN
END key.
2. Press the AUTO RTN/AUTO PLAY key to turn on
the [AUTO RTN] LED.
3. Start playback a little before the AUTO RTN END
point.
The recorder operates as shown in the diagram.
• You can set a preroll time in the [Preroll Time ?] menu
in SETUP mode so that the recorder will start playback
preroll time before the locate point. You can set the
preroll time from 0 to 10 seconds. Refer to the
chapter “Changing the Initial Settings (SETUP Mode)”
on page “ 108 .”