FUJITSU MHV2120AT - Manual (Page 21)

Contents
C141-E218 xvii
Figure 5.2 Execution example of READ MULTIPLE command .....................5-63
Figure 5.3 READ SECTOR(S) COMMAND protocol ...................................5-130
Figure 5.4 Protocol for command abort ..........................................................5-131
Figure 5.5 WRITE SECTOR(S) command protocol.......................................5-133
Figure 5.6 Protocol for the command execution without data
transfer ...........................................................................................5-135
Figure 5.7 Normal DMA data transfer ............................................................5-136
Figure 5.8 Ultra DMA termination with pull-up or pull-down .......................5-148
Figure 5.9 PIO data transfer timing.................................................................5-149
Figure 5.10 Multiword DMA data transfer timing (mode 2) ............................5-150
Figure 5.11 Initiating an Ultra DMA data in burst............................................5-151
Figure 5.12 Sustained Ultra DMA data in burst................................................5-155
Figure 5.13 Host pausing an Ultra DMA data in burst .....................................5-156
Figure 5.14 Device terminating an Ultra DMA data in burst............................5-157
Figure 5.15 Host terminating an Ultra DMA data in burst ...............................5-158
Figure 5.16 Initiating an Ultra DMA data out burst..........................................5-159
Figure 5.17 Sustained Ultra DMA data out burst..............................................5-160
Figure 5.18 Device pausing an Ultra DMA data out burst................................5-161
Figure 5.19 Host terminating an Ultra DMA data out burst .............................5-162
Figure 5.20 Device terminating an Ultra DMA data out burst..........................5-163
Figure 5.21 Power-on reset timing ....................................................................5-164
Figure 6.1 Response to power-on ........................................................................6-3
Figure 6.2 Response to hardware reset................................................................6-4
Figure 6.3 Response to software reset.................................................................6-5
Figure 6.4 Response to diagnostic command ......................................................6-6
Figure 6.5 Sector slip processing ......................................................................6-10
Figure 6.6 Automatic alternating processing ....................................................6-11
Figure 6.7 Data buffer structure ........................................................................6-12