Rps and eps input port, Power connector, Switch features – HP PROCURVE 2610 User Manual
Page 22: Rps and eps input port -12, Power connector -12, Switch features -12
1-12
Introducing the Switch
Switch Features
In
tr
o
d
u
c
in
g
th
e
Sw
itc
h
RPS and EPS Input Port
The 2610 Switches support connectivity to a redundant power supply (RPS/
EPS). The ProCurve 600 Redundant and External Power Supply (J8168A) and
the ProCurve 610 External Power Supply (J8169A) are accessory products for
these switches. The RPS functionality of the 600 procides redundant system
power in case the switch’s internal power supply fails. The EPS functionality
of the 600 and the 610 provides additional PoE power.
Power Connector
The 2610 Switches and 2610-PWR Switches do not have a power switch; they
are powered on when connected to an active AC power source. The switches
automatically adjust to any voltage between 100-127 and 200-240 volts and
either 50 or 60 Hz. There are no voltage range settings required.
Switch Features
The features of the 2610 Switches and 2610-PWR Switches include:
■
24, or 48 auto-sensing 10/100Base-TX RJ-45 ports with Auto-MDIX.
■
4 Uplink ports—two are 1000Base-T RJ-45 and two are mini-GBIC (SFP)
slots.
■
Power over Ethernet (PoE) operation—the 2610-PWR Switches are IEEE
802.3af compliant and provide up to 15.4W per port to power IP phones,
wireless access points, web cameras, and more. For more information,
see the PoE Planning and Implementation Guide, which is on the
ProCurve Web site at
■
The 2610-PWR Switches support some pre-standard PoE devices.
However, the use of a cross-over cable may be required. For a current list
see the FAQ page for the 2610-PWR Switch, which can be found on the
ProCurve Web site
echnical Support,
FAQs (all).
■
Plug-and-play networking—all ports are enabled—just connect the
network cables to active network devices and your switched network is
operational.
■
Auto-MDIX on all twisted-pair ports, 10/100 and 10/100/1000, meaning that
all twisted-pair connections can be made using straight-through cables.
Cross-over cables are not required, although they will also work.
■
Automatic learning of the hardware addresses in each switch’s 8000-
address forwarding table, (with configurable address aging value).