Operating characteristics of the 610 eps (j8169a) – HP PROCURVE 2610 User Manual
Page 44
2-20
Installing the Switch
Installation Procedures
In
sta
llin
g
th
e
Sw
itc
h
The RPS/EPS supports hot plugging of the RPS/EPS cable without causing a
reboot of the switch or causing the power supply in either the RPS/EPS or
switch to shut down temporarily or permanently. For more information refer
to the documentation that came with the RPS/EPS.
Operating Characteristics of the 600 RPS/EPS (J8168A)
The 600 RPS/EPS has six RPS ports, each of which can provide redundant
+12V power to a connected switch, but only one connector can provide this
power at a given time.
If a switch with no AC power is connected to an operating 600 RPS/EPS, it
will receive power if power is available (no higher priority port is already using
the RPS power).
If two or more devices fail, priority goes to the device plugged into the lower
numbered port on the 600 RPS/EPS unit. Consequently the most important
switch should be plugged into port one on the 600 RPS/EPS. In this state, the
“Connected” LED should be ON, and the “Power Status” LED should be
flashing on the lower priority RPS port not supplying power. (Refer to the
documentation that came with your 600 RPS/EPS unit.)
The 600 RPS/EPS also has two EPS Ports. The 600 RPS/EPS can provide a
maximum of 408 watts of PoE power to a switch. It is important to understand
the PoE power requirements of the 2610-PWR Series switches because if the
PoE power is not planned and implemented correctly the end devices
connected to the switch ports may not receive power if an internal switch PoE
power supply should fail. For further information regarding the 600 RPS/EPS
PoE capabilities, see the PoE Planning and Implementation Guide and the
ProCurve 600/610 External Power Supplies Installation and Getting Started
Guide
, which is on the ProCurve Web site at
(See
For redundant AC power, connect the 600 RPS/EPS to the switch using one
of the six supplied RPS cables. RPS cables are 1.25 meters (4.10 feet) in length.
For redundant or additional PoE power, connect the 600 RPS/EPS to the
switch using one of the two supplied EPS cables. EPS cables are 2.00 meters
(6.56 feet) in length.
Operating Characteristics of the 610 EPS (J8169A)
The 610 EPS does not have any RPS ports and can not supply RPS power. It
has four EPS Ports. You can connect one to four ProCurve PoE capable
switches to provide PoE power as a primary or backup source. Two in Pair A
and two in Pair B. Power is equally shared between the EPS ports in pair A
(that is, port A1 and A2) and between the EPS ports in pair B (port B1 and B2)