HP PROCURVE 2610 - Manual (Page 17)

1-7
Introducing the Switch
Front of the Switch
In
tr
o
d
u
c
in
g
th
e
Sw
itc
h
See the ProCurve 600/610 External Power Supplies Installation and Getting
Started Guide
for information on the LED behavior of the external power
supplies.
Test
(green/
orange) Off The normal operational state; the switch is not undergoing self test.
On The switch self test and initialization are in progress after the switch has
been power cycled or reset. The switch is not operational until this LED
goes off. The Test LED also comes on briefly when you “hot swap” a mini-
GBIC into the switch; the mini-GBIC is tested when it is hot swapped.
Flashing
orange
2
A component of the switch has failed its self test. The switch Fault LED,
Test LED, and the failed component LED will flash simultaneously.
1
The flashing behavior is an on/off cycle once every 0.8 seconds approximately, a fast flash.
2
The flashing behavior is an on/off cycle once every 1.6 seconds approximately, a slow flash.
3
ProCurve Switch 2610-PWR Series only.
Switch LEDs State Meaning