HP PROCURVE 2610 - Manual (Page 29)

2-5
Installing the Switch
Installation Procedures
In
sta
llin
g
th
e
Sw
itc
h
8. (Optional) Connect a console to the switch ( page 2-26 ). You may
wish to modify the switch’s configuration, for example, to configure an IP
address so it can be managed using a web browser, from an SNMP network
management station, or through a Telnet session. Configuration changes
can be made by using the included console cable to connect a PC to the
switch’s console port.
At this point, your switch is fully installed. See the rest of this chapter if you
need more detailed information on any of these installation steps.