Akg DMM8 ULD Digital Automatic Microphone Mixer with LAN and DANTE Interface - Manual (Page 125)

operAting the Device
DMM8 MANUAL 125
8.12 Copying configuration data
The copy function can be used to copy individual or multiple settings
(
LEVEL, TREBLE, BASS, LOWCUT, LIMITER and COMPRESSOR ) on an
input to one or more other inputs.
8.12.1 Copying individual values
To copy individual values from one channel to one or more other channels,
proceed as follows:
Step Description
1 Select the required function on the SYSTEM CONTROL rotary
knob
2 Press the rotary knob with the value to be copied, then
straight away press the rotary knob up to which the copy
process is to be carried out
3 Keep both rotary knobs pressed down (approx. 4 seconds)
until an acoustic signal is sounded (beep) and the affected
LED rings flash once briefly.
• Value was transmitted to the selected channels.
The copying process is applied to all rotary knobs that located between the
two selected knobs.
8.12.2 Copying all values
To copy all values from one channel to one or more other channels, proceed
as follows:
Step Description
1 Press the rotary knob with the values to be copied, then
straight away press the rotary knob up to which the copy
process is to be carried out
Copy
configurations