Sony VCT-SP2BP Camcorder Shoulder Support - Manual (Page 35)

35
To release monitor audio level mode
1
Press and hold the SET button, MENU button, or
NFC SYNC button for one second or longer until
“ESCAPE?” is displayed.
2
Press the + or – button to display “YES,” and press
the SET button.
The lock state is released.
• This function is released when the power is turned off.
Reconfigure the setting after the power is turned on.
• When the POWER switch is set to the OFF position, the
power of each tuner is also turned off.
Selecting the preferred power supply
(POWER SOURCE)
Specifies whether the power supply from the batteries
inserted in the unit or from an external USB portable
power supply or accessory connected to the USB
connector or auxiliary connector has precedence.
BATT->EXT: Batteries inserted in the unit have
precedence.
EXT->BATT: Power supplied from a USB connector or
externally connected sources have precedence.
BATT ONLY: Batteries inserted in the unit are used, and
power supplied from the USB connector or auxiliary
connector is not used even after the batteries are
discharged.
When BATT->EXT or EXT->BATT is specified and
power from the preferred source is cut off, the power
supply automatically switches to the other source.
Therefore, when only one power supply is available, that
power supply will be used regardless of the POWER
SOURCE setting. There may be a brief interruption in the
audio when the power supply switches.
Configuring using communication with
the transmitter (SYNC MODE)
Sets the communication method for setting the transmitter
channel and compander mode. When using NFC
communication, the channel and compander mode set on
the transmitter are applied on the unit.
NFC: Configure using NFC communication.
IR: Configure using infrared communication.
The communication method will vary depending on the
transmitter. Configuring using communication is not
possible if the combination with the SYNC MODE
setting is not correct.
Selecting the scan type (SCAN TYPE)
Selects the scan type when the NFC SYNC button is
pressed, and the Clear Channel Scan and Active Channel
Scan scan types.
GROUP: Scan the currently selected channel group.
ALL BAND: Scan the receive frequency band within a
single TV channel and simultaneously scan each group
that supports multiple channel operation.
• With ALL BAND, the group to scan is fixed. To scan
other groups, select GROUP.
• The SCAN TYPE menu is not available on the Japan
model, Korea model, 90U model, and E model, so
SCAN TYPE cannot be selected.
For details about the groups and channels in each
frequency band, refer to the “Frequency List”.
Setting the battery type (BATTERY TYPE)
You can set the type of battery being used in order to
provide a more accurate battery level indication.
TYPE1: Recommended setting when using alkaline LR6
(size AA) batteries. Indicates the battery level based on
the characteristics of new alkaline LR6 (size AA)
batteries from a specific manufacturer.
TYPE2: Recommended setting when using 2000 mAh
rechargeable nickel metal hydride batteries.
TYPE3: Recommended setting when using lithium
batteries.
TYPE4: Recommended setting when using 2500 mAh
rechargeable nickel metal hydride batteries.
The characteristics of batteries change according to
battery type and environmental conditions. It is
recommended that you understand the characteristics of
batteries before using them.
Notes
Note
Note
Communication method
for configuration on
each transmitter Tuner
URX-P41D
NFC
communication Infrared
communication
Transmitter
UTX-B40 a a
UTX-M40 a a
UTX-P40 a a
UTX-B03 × a
UTX-B03HR × a
UTX-M03 × a
UTX-P03 × a
UWP-series
transmitter Ч Ч
WRT-series
transmitter Ч Ч
Notes
Note