Sony VCT-SP2BP Camcorder Shoulder Support - Manual (Page 12)

12
For details about the muting function, see “Setting the
operation of the audio muting function (POWER/MUTE)
(UTX-M40 only)” (page 42).
F Battery level indicator
Displays the battery level.
For details, see “Battery level indicator” (page 19).
G Menu display section
Displays various functions. Press the + or – button to
switch functions.
For details, see “Configuration menu” (page 41).
H Gain mode indicator
Displays the gain mode setting.
For details, see “Setting the audio gain (GAIN MODE)”
(page 41).
h Infrared detector
Receives the frequency and compander mode set on the
tuner.
i SET button
Adjusts displayed function settings and enters the
displayed value.
Holding down the SET button while turning on the power
turns the transmitter on without transmitting a signal
(transmission stopped mode).
j USB connector (USB Type-C)
For use by service personnel.
k POWER button
Turns the power on/off.
l + or – button
Selects functions or values shown on the display.
Plug-on transmitter (UTX-P40)
a Audio input connector (XLR type)
Connect to a microphone or the line output of an audio
mixer or other device.
b +48V (+48 V supply) indicator
Lights up when the unit is set to MIC input and is
supplying power to the connected microphone.
c POWER indicator
Displays the battery level.
d AUDIO (audio input level) indicator
Turns on or off according to the audio input level as
follows.
On (red): Audio input level is too high. If the sound is
distorted, adjust the attenuation level to decrease the
audio input level
(page 41) .
On (green): Audio input level is appropriate.
Off: There is no audio input or the input level is too low.
Flashing (orange): Audio is muted (i.e., disabled).
Indicator display Status
On (green) Sufficient battery level
Flashing (green) Battery is getting low
Off Supply OFF
Front
Bottom