Yamaha CVP-705B - Manual (Page 97)

CVP-709/CVP-705 Owner’s Manual 97
C
on
n
ec
tio
n
s – U
sin
g Y
our I
n
str
u
men
t w
ith
O
th
er
D
ev
ices
–
You can connect a USB flash drive or a USB wireless LAN adaptor to the [USB TO DEVICE] terminal. You
can save data you’ve created on the instrument to the USB flash drive (page 33), or you can connect the
instrument to a smart device such as iPad via a USB wireless LAN adaptor (page 98).
Connecting USB Devices ([USB TO DEVICE] terminal)
Precautions when using the [USB TO DEVICE]
terminal
This instrument features a built-in [USB TO DEVICE]
terminal. When connecting a USB device to the
terminal, be sure to handle the USB device with care.
Follow the important precautions below.
NOTE
For more information about the handling of USB devices, refer
to the owner’s manual of the USB device.
 Compatible USB devices
• USB flash drive
• USB wireless LAN adaptor (which is included only
in some areas)
Other USB devices such as a computer keyboard or
mouse cannot be used.
Although USB devices 1.1 to 3.0 can be used on this
instrument, the amount of time for saving to or
loading from the USB device may differ depending on
the type of data or the status of the instrument.
The instrument does not necessarily support all
commercially available USB devices. Yamaha cannot
guarantee operation of USB devices that you purchase.
Before purchasing a USB device for use with this
instrument, please visit the following web page:
http://download.yamaha.com/
NOTE
The rating of the USB TO DEVICE terminal is a maximum of 5V/
500mA. Do not connect USB devices having a rating above
this, since this can cause damage to the instrument itself.
 Connecting a USB device
When connecting a USB
device to the [USB TO
DEVICE] terminal, make
sure that the connector on
the device is appropriate
and that it is connected in
the proper direction.
NOTICE
• When connecting a USB device to the [USB TO DEVICE]
terminal on the top panel, remove it before closing the
key cover. If the key cover is closed with the USB device
connected, the USB device may be damaged.
• Avoid connecting or disconnecting the USB device while
executing playback/recording and file management
operations (such as Save, Copy, Delete and Format), or
when accessing the USB device. Failure to observe this
may result in “freezing” of the operation of the
instrument or corruption of the USB device and the data.
• When connecting then disconnecting the USB device
(and vice versa), make sure to wait a few seconds
between the two operations.
NOTE
When connecting a USB cable, make sure that the length is
less than 3 meters.
Using USB flash drives
By connecting the instrument to a USB flash drive,
you can save data you’ve created to the connected
device, as well as read data from the connected USB
flash drive.
 Maximum number of USB flash drives
Up to two USB flash drives can be connected to the
[USB TO DEVICE] terminal.
 Formatting USB flash drives
You should format the USB storage device only with
this instrument (page 98). A USB storage device
formatted on another device may not operate properly.
NOTICE
The format operation overwrites any previously existing
data. Make sure that the USB flash drive you are formatting
does not contain important data. Proceed with caution,
especially when connecting multiple USB flash drives.
 To protect your data (write-protect)
To prevent important data from being inadvertently
erased, apply the write-protect provided with each
USB flash drive. If you are saving data to the USB flash
drive, make sure to disable write-protect.
 Turning off the instrument
When turning off the instrument, make sure that the
instrument is NOT accessing the USB flash drive by
playback/recording or file management (such as
during Save, Copy, Delete and Format operations).
Failure to do so may corrupt the USB flash drive and
the data.