Yamaha CVP-705B - Manual (Page 105)

CVP-709/CVP-705 Owner’s Manual 105
CVP
-70
9 A
ssem
bl
y
CVP-709 Assembly
CAUTION
• Assemble the unit on a hard and flat floor with ample space.
• Be careful not to confuse or misplace the parts, and be sure to
install all parts in the correct orientation. Please assemble the
unit in accordance with the sequence described here.
• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified sizes.
Do not use any other screws. Use of incorrect screws can cause
damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly of each
unit.
• To disassemble the unit, reverse the assembly sequence.
Remove all parts from the package and make sure you have all
of the items.
1
Lean unit A against the wall as shown.
Spread a large soft cloth, such as a blanket, as shown to
protect the floor and wall surfaces.
Lean unit A against the wall with the key cover closed and
the keyboard side on the bottom.
CAUTION
• Be careful not to pinch your fingers.
NOTICE
• The top part of the music rest is not fixed. Support the music
rest with your hand so that the music rest will not fall.
• Do not place the main unit upside down or with the rear side
facing down.
Have a Phillips-head (+) screwdriver of the appropriate size ready.
5 x 30 mm x 4
H
4 x 20 mm x 3
M
4 x 10 mm x 2
P
To prevent the key cover from accidentally opening during assembly,
press down on the key cover, making sure that the sheets (shown) remain
in place.
To prevent damage to the speaker box located at the bottom of unit A,
make sure to place unit A on the styrofoam pads. Also, make sure that the
pads do not touch the speaker box.
Bundled pedal cord
inside. The pedals are
covered with covers
when shipped from the
factory. Remove the
cover from the damper
pedal for optimum use
of the GP Responsive
Damper Pedal effect.
Power cord Protective pads x 2 Headphone
hanger
CVP-709PWH
5 x 18 mm x 4
(a)
(a) (b) (c) (d)
(b)
(c)
(d)
x 6
x 8
x 6
(a)
(a) (b) x 2
(b)
4 x 12 mm x 2
4 x 13 x 2.5 mm x 2
CVP-709B/CVP-709PE
N
5 x 18 mm x 10
4 x 10 mm x 2 5 x 15 x 1.2 mm x 4
J, L
J
Q
K
N
6 x 13 x 2.5 mm x 6
5 x 20 mm x 6
5 x 16 x 2 mm x 6
L
Large soft cloth
Styrofoam
pads
NOTICE
Do not touch the speaker net.
Doing so may damage the
speaker inside.
Protective pads
Protective pads