Yamaha CVP-705B - Manual (Page 113)

CVP-709/CVP-705 Owner’s Manual 113
T
roubl
esho
ot
ing
(MIDI)
The Guide lamps do not light during Song
playback, even after turning on the Guide
function. Any notes outside of the 88-key range cannot be indicated by the Guide
lamps.
(MIDI)
The Guide lamps light an octave or two lower/
higher than the actual pitch. The Guide lamps sometimes light an octave or two lower/higher than the
actual pitch depending on the selected Voice.
(MIDI)
The tempo, beat, measure and music notation
is not displayed correctly. Some Song data for the instrument has been recorded with special “free
tempo” settings. For such Song data, the tempo, beat, measure and
music notation will not be displayed correctly.
A message indicating the USB flash drive is
unavailable appears, and the recording is
aborted. Make sure to use a compatible USB flash drive (page 97).
Make sure that the USB flash drive has enough memory (page 98).
If you are using a USB flash drive to which data has already been
recorded, check first that no important data remains on the device, then
format it (page 98) and try recording again.
The Song playback volume differs depending
on the selected Song. The volume of MIDI Songs and Audio Songs are set independently. Adjust
the volume in the Balance display (page 42) after selecting a Voice.
Microphone
The microphone input signal cannot be
recorded. The microphone input signal cannot be recorded by MIDI recording.
Record by using Audio recording (page 75).
Harmony can be heard in addition to the
microphone sound. Vocal Harmony is set to “On.” Turn Vocal Harmony off (page 83).
The Vocal Harmony effect sounds distorted or
out-of-tune. Your vocal microphone may be picking up extraneous sounds, such as
the Style sound from the instrument. In particular, bass sounds can cause
mistracking of Vocal Harmony. To remedy this:
• Sing as closely to the microphone as possible.
• Use a unidirectional microphone.
• Turn down the Master volume, or adjust the volume balance on the
Balance display (page 42).
The Vocal Harmony effect is not applied even
when it is turned on. In the Chordal mode, Vocal Harmony is added only when chords are
detected. Try one of the following:
• Turn on the [ACMP ON/OFF] button and play chords in the chord
section during Style playback.
• Turn on the Left part and play chords in the left hand section.
• Play back a Song which contains chords.
• Set the “Stop ACMP” parameter to something other than “Disabled” via
[Menu]  [StyleSetting]  [Setting]. For details, refer to the Reference
Manual on the website (page 9).
Mixer
The sound seems strange or different than
expected when changing a rhythm Voice
(drum kit, etc.) of the Style or Song from the
Mixer. When changing the rhythm/percussion Voices (drum kits, etc.) of the Style
and Song from the VOICE parameter, the detailed settings related to the
drum voice are reset, and in some cases you may be unable to restore the
original sound. You can restore the original sound by selecting the same
Song or Style again.
Song