ATL Telecom OM100 User Manual
Page 23
Top level
Sub level
Description
Alarms
Status
Displays the current alarm status.
History
Review the fault log. View recorded alarm events.
Severity Level Settings
Set fault level. Configure Urgent & Non urgent
alarm sources.
Configuration
Master / Slave
Master / slave configuration.
User Port
Configure each E1 port – enable.
Protection Switching
Configures the 1+1 protection switching.
System
Set date, time and menu timeout.
Subsystem Names
Enter name, description and location of this unit.
Monitoring Mode
Configures monitoring mode.
Software
Allows the downloading of software to the unit
and allows reset to factory default.
Serial Communications
Local terminal set-up – baud rate, parity, handshake.
Reboot
This option allows you to reboot the unit that you
are using, as well as its remote partner.
Front Panel
Allows configuration of Front Panel controls.
Information
Displays the designation of the unit.
Logout
Logout of the menus and enter
monitoring mode.
Performance
Optical Transmission Line Counter and status indicators for the optical lines.
User Port
Counter and status indicators for the user ports.
Security
Change
passwords.
Test
Enables various loopbacks.
7
M E N U T O P O L O G Y
ATL USER GUIDE
OM100 Optical Multiplexer
43
7
42
ATL USER GUIDE
OM100 Optical Multiplexer
For example: To disable a port – move the cursor to the check box, press the space bar and
then press
6.3.4
How radio buttons work
These are multiple choice check boxes. Only one can be active (mutually exclusive).
In this example “Parity” can be set to one of three possible options; None, Odd, or Even.
It would not make sense to set it to be both Odd and Even at the same time, so we only
allow one of the three options to be set.
To change the Parity from NONE to ODD – move the cursor to the ODD box, and press the
space bar. Remembering to press
Parity
None (*)
Odd ( )
Even ( )
Parity
None ( )
Odd (*)
Even ( )
Enable [X]
Enable [ ]