Quintum Technologies Call Routing Server - Manual (Page 21)

P/N 480-0028-00-00 2-10
Chapter 2: Hardware Installation
Connect the unit
The following steps are required to fully connect the Call Routing Server:
• Connect to Ethernet LAN port
• Power up the system
Connect to Ethernet LAN 10/100 hub/switch
NOTE: Connection to one Ethernet hub/switch is required for initial installation.
You can use these instructions for general connection only. The Ethernet hub/switch documentation should
provide specific instructions for connection to another device, such as the Call Routing Server.
Figure 2-6 Connect to Ethernet Hub/Switch
1. Insert one end of the RJ-45 cable into the unit’s port labeled LAN 1 port. (LAN 2 port is reserved for future
use.
2. Insert the other end of the RJ-45 connector into an appropriate Ethernet port. See your Ethernet documen-
tation port requirements for connection specifics. (If another cable or adaptor is required, see Chapter 2:
Hardware Components for connector pinout information.)
Ethernet Hub/Switch
LAN 1 LAN 2 10101
ESC ENTER
LAN 1
for 10/100
connection