AltiGen MAXCS 7.0 Update 1 FXS Configuration with AudioCodes User Manual

Page 9

Configuring Analog Extensions with AudioCodes Gateways

Page 9 of 25

Select VoIP > Media > Analog Settings. Configure the settings as follows:

Note: The AudioCodes device requires a reboot after you change either of these settings. You can reboot once

all configuration is complete, during the last step on page 17.

Select VoIP > Control Network > Proxy Sets Table. Configure Proxy Set ID 0 as follows:

Figure 12: Configure the proxy IP address and transport type

•

Set Proxy Address 1 to 10.40.1.43:10060 (The

MaxCS public IP address and port). Set its

Transport Type to UDP.

•

Set Enable Proxy Keep Alive to Disable.

•

Set Min. Hook-Flash Detection Period [msec] to 300.

•

Set Max. Hook-Flash Detection Period [msec] to 800.

Figure 11: Configure the minimum and maximum detection periods