AltiGen MAXCS 7.0 Update 1 FXS Configuration with AudioCodes - Manual (Page 18)

Configuring Analog Extensions with AudioCodes Gateways Page 18 of 25
2. Click the Register button.
Figure 27: Register the phone extension
3. Log into MaxCS 7.0 MaxAdministrator. Open the Extension view; extension 167 should be listed there.
Figure 28: The extension appears in Extension View in MaxCS Administrator
4. Attach an analog phone to the first FXS port and make a few calls to test that everything works correctly.
5. If everything works correctly, return to the AudioCodes configuration tool and click the Maintenance button
above the menu (see the next figure). Then select Software Update > Load Auxiliary Files.
At this point, you will upload the two files that came with this configuration guide, as mentioned in the sec-
tion Prerequisites on page 4.
• usa_tones_13_NoHold.ini
• usa_tones_13_NoHold.dat
Note: If you do not load these files, callers may hear an on-hold beep tone while calls are being connected
or disconnected.