Industrial Data Systems IDS 152 - Manual (Page 29)

3.4.3 CONFIGURATION: MULTIPLIER.
NOTE: Used with pulse input only. Each pulse in is
multiplied by the multiplier factor.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 7.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 3.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 for 1
1 for .1
2 for .01
3 for .001
4 for .0001
5 for 10
6 for 100
7. Press the ENTER switch. The ENTER light turns off.
DECIMAL POINT
FLASH ON OFF (Enter Light)
Set 1 7 3 0 (Thumbwheel Switch)
Set .1 7 3 1 (Thumbwheel Switch)
Set .01 7 3 2 (Thumbwheel Switch)
Set .001 7 3 3 (Thumbwheel Switch)
Set .0001 7 3 4 (Thumbwheel Switch)
Set 10 7 3 5 (Thumbwheel Switch)
Set 100 7 3 6 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode
postition after configuration.