Industrial Data Systems IDS 152 - Manual (Page 26)

3.4 CONFIGURATION OF WEIGHING APPLICATION OPTIONS.
If you are using one of the weighing 'SPECIAL APPLICATION'
modes then the following must be configured:
Section 3.4.1
SELECT SCALE METER TYPE.
Section 3.4.2 CONFIGURE SCALE UNITS.
If pulse input is being used then also configure:
Section 3.4.3
DECIMAL POSITION.
Section 3.4.4 COUNT/PULSE FACTOR.
The
'SPECIAL APPLICATION' modes are selected by IDS152 by reading the
thumbwheel
switch on power up.
THUMBWHEEL
POSITION APPLICATION MODE
0 BASIC PRINTER MODE.
1 PRINT WEIGHT ONLY.
2 PRINT WEIGHTS WITH GROSS, AND TARE LABELS.
3 GROSS, TARE, NET PRINTING.
4 PRINT AND TOTAL.
5 PRINT, SUBTOTAL, AND TOTAL.
6 PRINT AND TOTAL ( AXLE WEIGH ).
7 WEIGH-IN, WEIGH-OUT.
If position 0 (BASIC MODE) is used then ignore section 3.4.
The section 3.4 configurations have no effect in BASIC MODE.
REMEMBER: Return the thumbwheel switch to the correct mode
postition after configuration
.