Industrial Data Systems IDS 152 - Manual (Page 14)

3.2 CONFIGURE PRINT FEATURES.
The following list shows how the print features are set at the
factory.
3.2.1 AUTO LINE-FEED AFTER CR = ON
3.2.2 AUTO PAPER RELEASE = ON
3.2.3 AUTOMATIC PRINT WRAP = ON
3.2.4 MULTI-STRIKE PRINT = OFF
3.2.5 BI-DIRECTIONAL PRINT = ON
3.2.6 INVERT PRINT = OFF
3.2.7 INHIBIT PRINT IF PAPER EMPTY = ON
3.2.8 TOP MARGIN = 0
3.2.9 LEFT MARGIN = 0
3.2.10 PRINT SIZE = NORMAL
3.2.11 STATION NUMBER = DISABLED
3.2.12 PRINT ONLY HEADING = DISABLED
Use the following sections to change the settings.
CONFIGURATION: AUTOMATIC LINE FEED AFTER CARRAGE RETURN.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 1.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 1.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 for AUTO LF --- OFF
1 for AUTO LF --- ON
7. Press the ENTER switch. The ENTER light turns off.
SET AUTO LF AFTER CARRAGE RETURN
FLASH ON OFF (Enter Light)
Auto lf OFF 1 1 0 (Thumbwheel Switch)
Auto lf ON 1 1 1 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode
postition after configuration .