Industrial Data Systems IDS 152 - Manual (Page 27)

3.4.1 CONFIGURATION: SELECT SCALE METER TYPE.
1. Begin with the ENTER light OFF.
2. Turn the thumbwheel switch to position 7.
3. Press the ENTER switch. The ENTER light begins flashing.
4. Turn the thumbwheel switch to position 1.
5. Press the ENTER switch. The ENTER light turns on.
6. Turn the thumbwheel switch to position:
0 - NCI5790
1 - AN5316, continuous output mode.
2 - Condec, Accuweigh, Applied Forces,
MSI Transweigh, Streeter Q9000.
3 - A&D 4316, 4321, GENERAL 521.
4 - CARDINAL 738
5 - TOLEDO 8132, 8142 high speed mode.
6 - WI 110, 120.
7 - DR 10K.
8 - SSD800.
9 - Pulse Input.
7. Press the ENTER switch. The ENTER light turns off.
SET SCALE METER TYPE
FLASH ON OFF (Enter Light)
Set NCI5790 7 1 0 (Thumbwheel Switch)
Set AN5316 7 1 1 (Thumbwheel Switch)
Set Condec 7 1 2 (Thumbwheel Switch)
Set A&D / Gen. 7 1 3 (Thumbwheel Switch)
Set Cardinal 738 7 1 4 (Thumbwheel Switch)
Set Toledo 8142 7 1 5 (Thumbwheel Switch)
Set WI 110 7 1 6 (Thumbwheel Switch)
Set DR 10K 7 1 7 (Thumbwheel Switch)
Set SSD800 7 1 8 (Thumbwheel Switch)
Set Pulse Input 7 1 9 (Thumbwheel Switch)
REMEMBER: Return the thumbwheel switch to the correct mode
postition after configuration.