Industrial Data Systems IDS 152 - Manual (Page 13)

3.1 CONFIGURATION OF SERIAL COMMUNICATIONS PORT.
The baud rate and data format is set by the 8 position 'DIP'
switch, located behind the access panel at the back of the
printer.
Select the baud rate and data format from the table below.
Dip Switch 1: on = Current Loop Input off = not selected
Dip Switch 2: on = RS232 Input off = not selected
Dip Switch 3: on = Even Parity off = Odd Parity
Dip Switch 4: on = Disable Parity off = Enable Parity
Dip Switch 5: on = 7 Data Bits off = 8 Data Bits
NOTE: Do not set switches 1 and 2 on at the same time.
When using RS232 set dip switch 1 0ff, set dip switch 2 on.
When using Current loop set dip switch 1 on, set dip switch 2 off.
Dip Switches 6,7,8: Baud Rate Select
Baud Rate sw6 sw7 sw8
300 off off on
600 off on off
1200 off on on
2400 on off off
4800 on off on
9600 on on off
NOTE: Some dip switches use the following labels:
CLOSED = on
OPEN = off