American Fibertek SM8P-SFP - Manual (Page 70)

Rev.A1
18-May-11 62
Member Port:
This is used to enable or disable if a port is a member of the new added
VLAN, “Enable” means it is a member of the VLAN. Just tick the check
box (
)
beside the port x to enable it.
Add new VLAN:
Please click on to create a new Tag-based VLAN.
Input the VLAN name as well as VID, configure the SYM-VLAN function
and choose the member by ticking the check box beside the port No.,
then, press the button to have the setting taken effect.
Delete Group:
Fig. 3-19
Just press the button to remove the selected group entry from
the Tag-based group table.
Fig. 3-20
Note: If you need use PVLAN( Private VLAN) function on Switch then you
need follow up the process as below:
a. Create a VLAN as primary VLAN and the VLAN ID is 2 and evoke the Private
VLAN to enable Private VLAN service.
b. Assign port member to the VLAN2