American Fibertek SM8P-SFP - Manual (Page 216)

Rev.A1
18-May-11 206
Notification
reinitializing LLDP transmission. (Default: 2 secs)
Interval: A network management application can periodically check the
switch MIB to detect any missed change notification traps.
Refer to IEEE 802.1AB-2005 or later for more information.
(Default: 5 secs)
Mode : To enable or disable the LLDP mode per port. There are four
type includes Disable, Tx_Rx, Tx only and Rx only
Port Descr : To evoke the outbound LLDP advertisements, includes an
alphanumeric string describing the port.
Sys Name : To evoke the outbound LLDP advertisements, includes the
system’s assigned name
Sys Descr : To evoke outbound LLDP advertisements, includes an
alphanumeric string describing the full name and version
identification for the system’s hardware type, software version,
and networking application.
Sys Capa : To evoke outbound advertisements, includes a bitmask of
system capabilities (device functions) that are supported. Also
includes information on whether the capabilities are enabled.
Mgmt Addr : To evoke outbound advertisements, includes information on
management address. you can use to include a specific IP
address in the outbound LLDP advertisements for specific ports
Notification : To evoke outbound advertisements, includes information on
Notification.