American Fibertek SM8P-SFP - Manual (Page 366)

Rev.A1
18-May-11 320

Hardware Specifications
 Standard Compliance: IEEE802.3/802.3ab / 802.3z / 802.3u / 802.3x
 Network Interface:
Configuration Connector Port
10/100/1000Mbps TP Jack (RJ-45)
TP(RJ-45) 7 to 8
100/1000Mbps SFP Fiber Module
SFP 1 to 8
*Port 7, 8 are TP/SFP fiber dual media ports with auto detected function
*Optional SFP module supports LC or BiDi LC transceiver
 Transmission Mode: 10/100Mbps support full or half duplex
1000Mbps support full duplex only
 Transmission Speed: 10/100/1000Mbps for TP
1000Mbps for Fiber
 Full Forwarding/Filtering Packet Rate: PPS (packets per second)
Forwarding Rate Speed
1,488,000PPS 1000Mbps
148,800PPS 100Mbps
14,880PPS 10Mbps
 MAC Address and Self-learning: 8K MAC address
4K VLAN table entries,
 Buffer Memory: Embedded 1392 KB frame buffer
 Flow Control: IEEE802.3x compliant for full duplex
Backpressure flow control for half duplex
 Cable and Maximum Length:
TP Cat. 5 UTP cable, up to 100m
1000Base-SX
Up to 220/275/500/550m,
which depends on Multi-Mode Fiber type
1000Base-LX Single-Mode Fiber, up to10/30/50Km
1000Base-LX WDM (BiDi) Single-Mode Single Fiber, up to 20Km
 Diagnostic LED:
System LED : Power
Per Port LED:
1 to 8
100/1000 Dual Speed SFP Port : LINK/ACT, 100/1000M
10/100/1000M TP Port 7,8 : TP(LINK/ACT), Speed