IEI Integration SRM_121_150 v1.11 - Manual (Page 111)

SRM-121/SRM-150 LCD Monitor
Page 97
8.1 Gasket Replacement
A gasket used for a long time may gradually lose its ability to protect the monitor from
fluids and vapors; scratches or dirt may also accumulate. It is recommended that the
gasket be replaced yearly.
NOTE:
If the monitor is mounted vertically, first remove it and place it on a flat,
level surface with the display screen facing down before changing the
gasket.
Step 1: Remove the old gasket from the sides of the monitor.
Step 2: Attach the new gasket to the monitor. Make sure the gasket fits precisely into the
groove along the edges of the monitor’s front panel (Figure 8-1).
Figure 8-1: Gasket Replacement
NOTE:
Compliance with the IP 65 standard depends on correct installation of
the gasket. Be sure to check that the gasket is properly installed after
changing it.