2 install the new psu – IEI Integration PPC-WIDS-51xxA-G41 User Manual

Page 126

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC

Page 114

Step 5:

Remove the retention screws that connect the PSU bracket to the chassis

Figure 6-8: PSU Rear Panel Screws

Step 6:

Remove the retention screws that connect the PSU to the PSU bracket.

Step 0:

6.6.2 Install the New PSU

Installation is done in the reverse order to removal. To install a new PSU module, please

follow the steps below.

Step 1:

Attach the PSU bracket to the PSU module with the previously removed

retention screws.

Step 2:

Insert the PSU module and bracket assembly into the chassis and attach the

PSU bracket to the chassis with the previously removed retention screws.

Step 3:

Secure the PSU module to the chassis by reinserting the previously removed

retention screws through the bottom panel.

Step 4:

Bundle the cables of the new PSU module and secure them with a plastic tie

similar to the old PSU module.

Step 5:

Reconnect all previously disconnected power connectors to the motherboard

and disk drives.

Step 6:

Reattach the elevated platform.

Step 7:

Replace the back cover.

Step 0: