IEI Integration PPC-WIDS-51xxA-G41 - Manual (Page 121)

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 109
WARNING!
Please take antistatic precautions when working with the internal
components. The interior of the PPC-51xxA-G41/WIDS-51xA-G41
contains very sensitive electronic components. These components are
easily damaged by electrostatic discharge (ESD). Before working with
the internal components, make sure all anti-static precautions
described earlier have been observed.
To access the panel PC internal components, the back cover must be removed. To
remove the back cover, please follow the steps below.
Please refer to Section 4.4 for back cover removal instructions.
6.4 DIMM Replacement
Please read the warnings at the beginning of the previous section before attempting to
access any PPC-51xxA-G41/WIDS-51xA-G41 internal components.
To install/replace the DIMM modules please follow the steps below.
Step 1: Remove the back cover (Section 4.4).
Step 2: Locate the DIMM socket on the motherboard near the right of the chassis. Push
down on the white levers of the socket until the DIMM module disengages from
the socket (Figure 6-1).