Pt100½ input modules sx5l-sbpt04x1 / sx5l-sbpt04y1 – IDEC SX5L Series User Manual
Page 25
2: H
ARDWARE
S
PECIFICATIONS
2-14
SX5L C
OMMUNICATION
T
ERMINAL
U
SER
’
S
M
ANUAL
Pt100
Ω Input Modules SX5L-SBPT04X1 / SX5L-SBPT04Y1
General Specifications
Pt100
Ω Input Specifications
Rated Power Voltage
24V AC (50/60Hz) / 24V DC compatible
Power Voltage Range
21.6 to 26.4V AC/DC (including 5% ripple)
Power Consumption
3.0 VA (24V AC), 1.8W (24V DC)
Power Inrush Current
15A maximum (24V AC/DC)
Allowable Momentary Power Interruption
10 ms minimum (at the rated power voltage)
Dielectric Strength
1,000V AC, 1 minute between power and FG terminals
Insulation Resistance
100 M
Ω minimum between power and FG terminals (500V DC megger)
Operating Temperature
0 to 55°C (no freezing)
Operating Humidity
30 to 90% RH (non-condensing)
Storage Temperature
–20 to +75°C (no freezing)
Storage Humidity
30 to 90% RH (non-condensing)
Pollution Degree
2 (IEC 60664)
Corrosion Immunity
Atmosphere free from corrosive gases
Altitude
Operation: 0 to 2,000m
Transpor t: 0 to 3,000m
Vibration Resistance
10 to 57 Hz amplitude 0.075 mm, 57 to 150 Hz acceleration 9.8 m/s
2
2 hours per axis on each of three mutually perpendicular axes
Shock Resistance
294 m/s
2
, 11-ms sinusoidal half-wave pulse
Mounting
35-mm-wide DIN rail, direct panel mounting (M4 mounting screws)
Weight (approx.)
250g
Type No.
SX5L-SBPT04X1
SX5L-SBPT04Y1
Input Points
4 points
Input Type
3-wire Pt100
Ω resistance thermometer
Temperature Measurement Range
0 to +50°C
–20 to +80°C
Digital Resolution
12 bits
Input Detection Current
1.0 mA maximum
A/D Conversion Time
80 ms per point
Sample Duration Time
1 sec
Allowable Conductor Resistance
100
Ω maximum (3 wires must have the same resistance)
Burnout
Yes (data: +327.67°C)
Error
±0.4% FS
Isolation between Input Channels
No isolation
Dielectric Strength
500V AC, 1 minute between input and FG terminals
500V AC, 1 minute between input and power terminals
Insulation Resistance
100 M
Ω minimum between input and FG terminals (500V DC megger)
100 M
Ω minimum between input and power terminals (500V DC megger)