IAI America SEP-PT - Manual (Page 101)

95
5. Operation of PMEC/AMEC Controller and ERC3
PMEC/AMEC controller and ERC3 is set to the full stroke movement as the position data when it is
delivered.
If a movement position change is required, connect SEP-PT Touch Panel Teaching to change the
setting.
5.1 Operation Status Chart
State Transition of the operation when PMEC/AMEC controller and ERC3 (MEC mode) is
connected is shown below:
No
Yes
Yes
e.g. for 3-point stop
No Yes
1
2
Position Setting List
(The windows are prepared
for each operation pattern).
Initial Setting
Parameter setting
Password input
(This window is skipped
when the system password
is set to
“0000”.)
e.g. for 3-point stop
MEC
Menu
Yes Operation
Pattern
No
Test Play
Midway Point Movement Method
3-point
2-point
Power supply ON
Title Display
*Displayed
for one second.
Red backlight is
turned ON.
Version Data
If the unit has never
been initialized since
it was purchased, the
“Initial Setting
Change Confirmation”
window appears
automatically.
Position Setting
Parameter Editing
Password Entry
(When the password is set
to the value except for
“0000” in the parameter
setting, this window is
displayed).
PosEdit
Pressing Force /Pressing Width
PosEDIT
Acceleration /Deceleration
Jog
Ecology
Home return
completion?
Inching
Completed
Uncompleted
Jog
Controller Re-startup
Initial Setting
Position Setting
Target Position/
Velocity
[Write] Button
Error Indication
When any error occurs in
the input range, etc., this
window is displayed. The
displayed message varies
depending on the error
contents.
No
Yes
Yes
Position Setting
Goes to the Target Position/ Velocity Window
.
No
Is there any
error?
V3.00 or later display
3 . 0 0
Monitor 1
Current Position
Current Speed
/Current Alarm
When an alarm is issued in the
Monitor, Jog, Inching or
Performance Test window, the
window is jumped to this one. Monitor 2
System Status,
I/O condition