Adaptec 48300 - Manual (Page 64)

Adaptec Flash Utility (AFU) ●
64
Example
This example shows a typical system response to a LIST command:
A:\> AFU LIST
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Controllers Detected and Recognized:
Controller #0 (03:01:00) Adaptec ASC-48300
SAVE
The SAVE command saves the contents of a HostRAID controller’s
flash in a UFI file. The name of the UFI file is based on the HostRAID
controller type and cannot be changed.
Command Syntax
The command syntax for the SAVE command is as follows:
AFU SAVE [/C] [/D ]
Command Switches
The following switches are available:
● /C is one or more HostRAID controller IDs
representing the set of controllers on which to perform the specified
command. The default is 0, which means that if the computer has
multiple HostRAID controllers, the AFU defaults to controller 0 unless
you specify otherwise.
You can specify a single HostRAID controller ID, for example:
/C 0
multiple IDs separated by commas, for example:
/C 0,2
or ALL to indicate all HostRAID controllers.
Note: If you are using multiple HostRAID controllers, you must
specify the controller you want by using the /C switch; otherwise,
the AFU displays an error message and exits. You cannot select ALL
HostRAID controllers when specifying SAVE.