Adaptec 48300 User Manual
Page 29
Installing the HostRAID Controller and Drives
●
29
7
On the next screen, respond as follows:
The Creating Array window is displayed.
Note:
RAID 1 and RAID 10, in clearing state the array is not
available to the operating system until clearing process is complete.
8
Press Enter to continue with the array configuration.
Note:
You can start using the array now. But, for a RAID 1 and
RAID 10, performance is reduced until the build process is
complete.
9
Press Esc until the Exit Utility window is displayed.
10
Highlight Yes, then press Enter.
The computer restarts.
11
Create the driver disk and install the driver as described in
Array Type
Select a RAID type, then press Enter.
Array Label
Type a name of no more than 15 characters, then
press Enter.
Stripe Size
Select stripe size, then press Enter. (N/A for RAID
1.)
Create RAID via
Select RAID option, then press Enter. (No Init is the
only option for RAID 0.)
[Done]
Press Enter.