8e6 Technologies 3 - Manual (Page 20)

20 8 E 6 T ECHNOLOGIES , E NTERPRISE R EPORTER 3.0 U SER ’ S G UIDE
A
DMINISTRATOR
S
ECTION
: C
HAPTER
1 - A
CCESSING THE
S
ERVER
Chapter 1: Accessing the Server
Preliminary Network Settings
To initially set up your ER 3.0 Server, follow the instructions in
the Quick Start Guide, the four-page leaflet packaged with
your ER 3.0. This guide explains how to perform the initial
configuration of the Server so that it can be accessed via an
IP address on your network.
NOTE: If you do not have the ER 3.0 Quick Start Guide,
contact 8e6 Technologies immediately to have a copy sent to
you.
Procedures for Accessing the Server
WARNING: Once you turn on the Server, DO NOT interrupt
the initial boot-up process. This process may take from five to 10
minutes per drive. If the process is interrupted, damage to key
files may occur.
When the Server is fully booted, any workstation on the
network that can access the Server’s IP address (set up
during Quick Start procedures) will be able to communicate
with the Server via the Internet.
1. Launch Internet Explorer (IE).
2. In the address line of the IE browser window, type in the
Server’s IP address. Port number “88” should be appended
to this IP address. For example, if your IP address is
1.2.3.4, type in http://1.2.3.4:88.
3. Click the Go button to open the login dialog box of the
Administrator GUI application.