Local printer—do not enable power detection, System target printer in a “stand-alone” setup, Changes needed on – Intermate 100 User Manual
Page 150: Changes needed on other configuration pages
Intermate100 and Intermate101 Print Server Administration Manual
150
Network Destination Option: Changes Needed on Other Configuration Pages
19.7.
Changes Needed on Other Configuration Pages
19.7.1. Local Printer—Do Not Enable Power Detection
When you enable NDO, you should also set “Enable Power
Detection” on the Local Printer to “No” (see
).
19.7.2. System Target Printer in a “Stand-Alone” Setup
The print server does not need to be physically attached to a
Local Printer. When thus used as “stand-alone”, only four tar-
get printers can be supported; and all four of them are network
destinations.
If you use this setup, you must be sure to set [General] > “Sys-
tem Target Printer” to a network destination (see
).
Otherwise you can end up hanging the whole system, because
everything carried by Logical Printer 0 as well as the “Main Sta-
tus Pages” gets directed to the System Target Printer.