Rockwell Automation 1784-PKTX_PKTXD Communication Card User Manual Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for 1784-PKTX_PKTXD Communication Card User Manual Rockwell Automation
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 38 |
| Size: | 1.12 MB |
Show table of contents
Document Outline
- Preface
- Table of Contents
- Chapter 1
- Introducing the Network Interface Cards
- Chapter 2
- Configuring the PKTx Hardware
- Chapter 3
- Installing the Card and the Drivers
- Accessing the PCI Bus Slots and Installing the Card
- Installing the Plug and Play Drivers
- 1. Upon startup, Microsoft Windows should detect the PKTX card and start the ‘New Hardware Wizard’. Click Next.
- 2. Insert your RSLinx CD into your CD-ROM drive (if it auto-starts, Exit the RSLinx installation).
- 3. When prompted by the New Hardware Wizard, select ‘Search for a suitable driver...’ and click Next.
- 4. When the ‘Locate Driver Files’ screen appears, select ‘Specify a location’ and click Next.
- 5. When prompted to specify the location, browse to ‘D:\RSLinx\PnP_Drivers’ (where D: is the CD-ROM drive with your RSLinx CD).
- 6. Follow decision table below:
- 7. Click OK.
- 8. Click Next.
- 9. Click Finish.
- What to Do Next
- Chapter 4
- Connecting the Network Interface Card
- 1784-PKTX Connections
- 1784-PKTXD Connections
- Before You Begin
- Connecting to DH+ Devices
- 1. Turn off power to the computer.
- 2. Connect the 3-pin Phoenix end of the CP12 cable to the PKTx card.
- 3. Connect the 9-pin D-shell end directly to the 9-pin D-shell connector on the front of the original PLC-5 processor.
- 4. Restore power to the computer.
- 1. Connect the 3-pin Phoenix end of the CP13 cable to the PKTx card.
- 2. Connect the adapter to the connector on the front of the enhanced PLC-5 programmable controller.
- Connecting the Card via a DH-485 Network
- Connecting to Remote I/O Devices
- Interpreting the Status LEDs
- What to Do Next
- Appendix A
- Specifications
- Index