Rockwell Automation 1784-PKTX_PKTXD Communication Card User Manual - Manual (Page 13)

Configuring the PKTx Hardware 2-3
Publication 1784-UM527B-EN-P - October 2003
When looking directly at the 1784-PKTx card, the Base Memory Address jumper looks like:
Using Multiple PKTx Cards
It is possible to have more than one PKTx card within your system. You can have up to four
cards functioning at the same time. There are two jumpers that can be set to establish unique
identification between the PKTx cards. The position and combination of the two jumpers
allow each card to be uniquely recognized by any application software.
The default position, card ID 0, has both jumpers in place.
32BIT
1MEG
32BIT
1MEG
This is a jumper that is not covered.
This is a jumper that has the 32bit position for
Windows 95 (or later) covered.
40022