HP PAVILION DX6500 - Manual (Page 77)

h . Audio board (see Audio board on page 71 )
i . USB/power connector board (see USB/power connector board on page 67 )
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
● Memory modules (see Memory module on page 43 )
● RTC battery (see RTC battery on page 45 )
● WLAN module (see WLAN module on page 46 )
● Bluetooth module (see Bluetooth module on page 65 )
● ExpressCard assembly (see ExpressCard assembly on page 72 )
● Fan/heat sink assembly (see Fan/heat sink assembly on page 74 )
● Processor (see Processor on page 77 )
Remove the system board:
1 . Press the ExpressCard slot bezel (1) to eject the bezel from the slot.
2 . Remove the ExpressCard slot bezel (2) from the slot.
3 . Remove the Phillips PM2.5×5.0 screw (3) that secures the system board to the base enclosure.
4 . Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an
angle.
5 . Disconnect the audio board cable (3) from the system board.
Component replacement procedures 69