HP COMBI 2180206H - Manual (Page 27)

Combi HP thermostatic mixer shower
Make sure all plumbing supplies are connected
and turned on.
Starting the shower
To start the shower, turn the outer knob (flow
control) anti-clockwise (fig.7).
Adjusting the shower temperature
To adjust the temperature, turn the inner
knob — temperature control (fig.7). The
temperature disc is numbered for ease of use
and ranges from 1 (fully cold) to 10 (fully hot).
Once at the preferred temperature, no further
adjustment is required, providing the hot and
cold water supplies remain constant.
Stopping the shower
To stop the shower, turn the flow control
clockwise to the stop position (fig.7). This
automatically stops the water flow.
As a safety measure the shower has a built-
in maximum temperature stop to prevent
accidentally exceeding the highest desired
temperature. The stop comes in a factory set
position. (If adjustment is required see ‘Adjusting
the maximum temperature stop’ on page 26).
To override this stop, depress the button and
turn the control clockwise to the higher settings
(fig.77). To return to the normal temperature
range just turn the temperature control
anti-clockwise until it is past the maximum
temperature stop.
Make sure that the temperature control is in the
normal temperature range when the shower is
turned off.
OPERATInG THE SHOwER
OPERATING THE SHOWER
T00291
Flow control
Fig.7
T00294
Maximum
temperature
override
button
Fig.77
T00292
Temperature
control
Fig.7
T00293
Flow control
Fig.7