HP COMBI 2180206H - Manual (Page 21)

9
Combi HP thermostatic mixer shower
correct way. Offer the valve up to the mounting
bracket and secure using the screws provided.
Secure the mounting bracket together with
the valve to the panel using two bolts in the
innermost fixing holes (fig.).
complete the pipework to the shower marking
off the length to enter the elbows. Remove the
valve and mounting bracket and cut the pipes
to length.
If fitting a fixed head, make a hole in the panel
for the fixed head position.
Note: Make sure the hole in the panel for the
outlet pipe is no larger than required (either
½” BSP or 15 mm).
Should the shroud protrude beyond the wall
surface, trim flush with a sharp knife (fig.).
Place a ring of silicon sealant round the flush
mount plate up to the finished surface. Make
sure the valve and plate are aligned, and secure
in the outer fixing holes using the two bolts
supplied (fig.7).
Break off the alignment tabs on the flush mount
plate (fig.) and fit the flush mount cover
(fig.8).
locate the lugs on the trim ring in the holes on
the cover and twist clockwise (fig.9).
complete the fitting of your shower accessories.
T00265
Fig.
T00268
Fig.9
T00266
Fig.7
T00267
Fig.8