Heath Zenith SL-6107 - Manual (Page 4)

595-4514-13 -4-
The switch may
indicate the
common
OR
Color of screw may
be different for the
common
INSTALLATION
1. Add Jumper At Remote 3-Way Switch.
A jumper wire between the common wire and one of the switched
wires is used to supply power to the SL-6107 regardless of the
position of the remote switch.
❐
Remove remote switch from the junction box.
❐
Connect the jumper wire to the common lug (usually labeled on
the switch) and to either one of the two switched lugs. If you're
not sure which lug is common, install the jumper on any two of the
wires, and test the jumper as explained on the next page.
Jumper
COMMON
Common Switch Lug
To brown wire of
SL-6107 (note color)
Connect Jumper at the Remote Switch
Hot Wire
To Red wire of SL-6107
(note color)